Cutting down Newtonians

[mick pinner]

just a hint for the tube cutters out there, as some may know l am a spray painter/panel beater and at work we use air operated panel shears for cutting steel up to 1.5mm, most panel shops use these shears and they will make a flawless cut. l would think that for a six pack or a few dollars it would take a friendly panel shop around 10 min to cut. just a thought.

[Lee]

The 1mm thickness discs do make a nice clean cut, just follow a carefully measured, remeasured, checked and rechecked guide-line, and you'll be fine!

[Manav (Yugant)]

I might have to do this soon. Did you end up documenting the process?

Ta