View Single Post
  #122  
Old 21-04-2017, 12:31 PM
mmalik (Mike)
Registered User

mmalik is offline
 
Join Date: Jul 2015
Location: USA
Posts: 106
Additional thermal separation of IBIS cover plate from the cold finger; cold finder in essence hangs free except for two contact points, one on the sensor and one on the base panel.


Even the loop of copper tape and the loop of (one of) the ribbon cables are separated by neoprene thermal insulation between the two.


I may have covered this earlier; here again since Rowland brought it up. Regards
Attached Thumbnails
Click for full-size image (ThermalSeparation.jpg)
159.4 KB22 views
Reply With Quote