[Paul Haese]

Something has occurred to me using focusmax. Every time the scope goes to focus it uses the luminance filter to focus. This is fine for LRGB imaging as the Lum image is the detail layer. However where this all comes undone is when doing narrowband imaging. I am yet to find that the lum filter is parfocal with the narrowband set.

Can you set the filter you want to focus with? I cannot seem to find it.

I know if I was using CCDautopilot I could set the filter I want to use for focus, but I am still integrating this into my automation plans and have not installed this yet.

Is there a solve to this problem?