Issue with older Argo
Hi,
Have just obtained an old Argo Navis (rectangular boxed version).
Had to make up serial cable, and a dual cable to connect the encoders.
When testing in Mode Encoder, either of the two encoders I have work perfectly on one channel, but not on the other. The faulty channel changes between 0 and 359.86 when the encoder is moved. Since the cables have been made identically, is it likely that the Argo is faulty? Anything else I should check? This happened with the original V2 firmware, and also after I reflashed with the latest firmware.....
cheers
Gary
|