View Single Post
  #5  
Old 05-04-2019, 06:28 AM
Malcolm
Registered User

Malcolm is offline
 
Join Date: May 2015
Location: Lismore NSW Australia
Posts: 201
You only need three adjustable feet, replacing the original rubber studs. I fitted three 19mm hardwood blocks, screwed and glued to the base to take the Bunnings adjustable feet. They have a nylon base and are adjusted by hand. I have two small spirit bubbles fitted each side of the mount base and one circular bubble fitted in front of the az motor. The bubbles were from eBay around a dollar each. If I'm on soft ground, such as a public park, I use three timber pads, each one has been drilled with a spade bit the same size of the feet halfway through the timber to prevent the mount sliding on the timber. I also have a small spirit level and a digital inclinometer for accuracy.
Reply With Quote