|
Thanks for those responses. I used to do exactly as Brent, fire up SGP and pick (Camera 1) and connect the 1600, which is on direct usb3 port on the laptop, then while cooling was starting I would connect the MBeat powered hub port switch for the asi120 which uses a separate usb3 port on the laptop. Start PHD2 and it would find the asi120.
Now for some reason, SGP still works as set out above, but PHD2 is oscillating between the 1600 and the 120, seriously I can watch it switch back and forth. When PHD is in this mode SGP locks up the 1600 and goes into a frame loop and shows rge camera as disconnected, as if PHD is looping the big camera (when it was never selected in PHD).
Driving me crazy.
I do have a spare HP Stream laptop that I could use to run PHD2 with the ASI120 connected directly to that machine. But I should not have to do that, as it was all working fine until recently. It's a WIN8 environment.
Last edited by glend; 05-05-2018 at 12:06 PM.
|