Hi Craig,
I use APT and just swapped over computers and had to get the platesolving set up again. Eventually, I got everything ok.
Here are my settings for Pointcraft:
ASTAP - downloaded and installed, pointing to the install location, for me: c:\Program Files\astap
ASTAP does not require any special config.
Use ASTAP for blind solve is NOT selected
PlateSolve2
downloaded and installed, pointing to the install location, for me: c:\platesolve\platesolve2.28
I installed APMM and UCAC3PSdirectly underneath platesolve2.28
Those directories had to be set in Platesolve2.exe
Use PS2 for near solving is NOT selected
ASPS - downloaded and installed, pointing to the install location, for me: c:\Program Files (x86)\Platesolver
You must run platesolver.exe to download the correct directories for your focal length
I hope that helps!!
cheers
Mark
|