[Hagar (Doug)]

Hi all I have a problem with my Q GUIDER guide camera. When I use it on my Observatory computer with PHD Guiding I end up during calibration with the screen scrolling over and over without calibration actually happening.
If I run the exact same software on my laptop it all works fine.
My original thought was that the desktop was running USB1 so a new PCI USB2 card was purchased, installed and it made no diference. The desktop is a 2.2 Ghz Celeron with 512 mb of ram, lots of free disk space. It is connected wit a 3 meter USB lead to my guide scope. The same setup drives perfectly when run with a DSI.

Any help or ideas would be appreciated.