|
Synscan Update
After running Synscan ver.3.27 successfully for a few years on my type 3 controller I thought I would upgrade to Synscan ver.03.39.05. The download went well but when I started it up I got the following responses:
- After initializing - Caution - then get message "Both axes-no response".
- Hit Setup and get Synscan ver.03.39.95
- Hit enter and goes straight to date setting.
- Proceed with correct date setting, time setting, daylight saving - yes.
- Hit enter and it goes back to Setup and date etc.
Any advice regarding this behaviour?
(Why did I leave ver.2.7?? Am tempted to go back to it if it is still available!)
|