View Single Post
  #3  
Old 03-10-2014, 07:39 PM
ZeroID's Avatar
ZeroID (Brent)
Lost in Space ....

ZeroID is offline
 
Join Date: May 2010
Location: Auckland, NZ
Posts: 4,950
Here's the Sensor front side view still attached to it's ribbon. Side view shows it to be a sandwich of glass and filter elements. The whole thing will therefore have to come off. I hacked around the edge of the glass trying to move it with no success but then a wee bit of pressure to the outside mounting plastic and it just peeled away. Just a slight blue green tinge to the bare filter. There is still a glass (?) surface over the actual sensor so it's safe enough from contamination.
Reassembly is reverse obviously, I left a few screws out, not needed in this case and I am thinking of a cold finger to that stainless plate if I can work out a way to seal it all against condensation.
Attached Thumbnails
Click for full-size image (07Sensor Frt0002.jpg)
170.6 KB14 views
Click for full-size image (08SensorSide0003.jpg)
90.9 KB15 views
Click for full-size image (09IROff0006.jpg)
196.2 KB15 views
Reply With Quote