Quote:
Originally Posted by gregbradley
I am not sure how you are mounted but if you have a pier that is on concrete set into the ground then rain can cause the soil to change and the pier to move a bit.
So your polar alignment may now be off.
You can save your t-point models. That way you can reload it if it disappears again.
Something to check.
Also if you changed the configuration of your scope/imaging train the flex may be different and t-point will need to either be redone or resynched. I was finding mine was off after putting a different camera on the scope. I would resynch it would be fine for the night then next use back to square one and I had to resync. I saved the synced T-point model and I load that once TSX is booted up and its all good.
Greg.
|
Good suggestions Greg
The mount is in the iTelescope shed. There is some serious concrete under this mount. I don't think there is any flex there.
The new T Point should be the goods - if its not, it will be interesting to see the pointing error.
Pete