I 3d printed some SHC handsets I found on thingiverse, as well as some buttons for the 5-way switches. Tried 2 different infills, which I think came out looking nice, although I do prefer the geometric infill (wavy lines) a bit more. Filament used is orange eSun glass PETG.
I tried connecting the motors, using estimated steps,etc but couldn’t get them to work. There is an error message popping up on the handset (Err!) which I can’t find any more documentation on so I’ll need to do a bit more investigating to resolve. This happens both with and without the motors connected so I’ll need to do some debugging. I have tested the handset fully using the SHC debugging program and with 2 different cables so the issue is most likely to be with the configuration or stepper wiring.
Last edited by sfarndell; 09-08-2020 at 12:48 PM.
|