Finally an update.
Managed to fit FTDI LQFP64 and ATMega328P and associated power then tried programming them...ahhh yeah didn't go so well at first. I was getting the following error... "Error reading device" in MProg.
Apparently I needed to fit the EPROM IC DD2 to the PCB, MProg was not reading the FDTI properly because its EPROM was missing! Go figure. Sigh!
Anyway after installing it ..all went well. Fusebits done, ATMEGA328P programmed, cam86 ASCOM installed ok, connected to cam86 view fine. Although not much to see as the PCB only has enough fitted to do firmware.