View Single Post
  #6  
Old 01-10-2019, 02:01 PM
sj777 (Dave)
Registered User

sj777 is offline
 
Join Date: May 2018
Location: Brisbane
Posts: 14
How did you go RussellH? I've just bought an NEQ6 and I'm looking at doing the same thing.



I have heaps of arduinos with on board FTDI USB-Serial interfaces so I followed a few tutorials on deactivating the ATMega chip to allow use o fthe TX and RX pins. Thus far I can't get EQMOD to connect to the mount



I've put my sillyscope on and verified it is TTL level serial comms. I've double checked the RX TX is wired correctly to the DB9 male connector which goes to the mount.



Looking for any help I can get
Reply With Quote