View Single Post
  #15  
Old 07-05-2012, 12:47 PM
troypiggo's Avatar
troypiggo (Troy)
Bust Duster

troypiggo is offline
 
Join Date: Nov 2008
Location: Brisbane, Australia
Posts: 4,843
I've pulled the camera apart, and it looks like I have "the old version" in the PDF that Martin posted above, Figure 2 left hand image. See my attached photo. Question time.

If I make it write protected, can it be undone easily if, for example, a firmware update needs to happen in the future?

The english in the document isn't crystal clear to me, and I don't find electronics intuitive. Is it just a matter of soldering those 2 right hand pins together? It mentions separating the pin from the board a couple of times. Early on says not to, then the unclear photo lower (Fig 3) seems to say to cut the wire.

Is there a software method of achieving this without soldering?
Attached Thumbnails
Click for full-size image (photo.jpg)
176.3 KB31 views
Reply With Quote