|
You may think a lot is being made of (coldplate) insulation but if you knew all that went into development of the rest of the module it is worth the extra effort.
So here are my thoughts...
1. I think 1/8" now with some experimental experience and improved application (corner coverage) will do a great job on the TEC side
2. On the coldplate perimeter, I feel 1/8" will also do the job and will look nice as well; there is a possibility of considering 3/16" for the perimeter
3. The camera side of the coldplate is something users will need to improvise given the foot print of the their camera; on areas extending beyond the camera, of course folks can go as thick as they wish. This is where 1/4" can be a possibility but in limited application. For most part I think 1/8" here will do the job as well. Regards
Note: Neoprene used is closed-cell and is of really good quality with strong native adhesive that bonds very strongly to the coldplate, and was imported form EU
Last edited by mmalik; 16-03-2016 at 06:41 AM.
|