Quote:
Originally Posted by bojan
Alex, not likely :-)
Motors are steppers and they can't be wired to "volume control pot" just like that...
If your friend can't help, I may be able to.
|
Thanks Bojan.
He is also looking at the paddle for the non goto.
It seems to me that the problem is with the on/off switch....ot ran for hours but when I yried later I had to jiggle the switch until finally no responce..I was going to solder the switch out by putting a wire on the board side...and use the power plig as switch on..it only has to run in ra...one speed..no need for controls.
Thanks again.
Ot will be interesting to see if this guy can fix it...I am hopeful of using this set up on m31. ...30 second captures approaxh.
Alex