|
Hi, yes, on rate 9, the fastest slew rate, up makes the scope go up, down makes it go down, left makes it go left and right makes it go right, so everything goes in the right direction it is suppose to go.
I didn't try to see if it goes back to the first star after the alignment, i will also check that out next time as well.
So it could actually be the SynScan hand controller unit that is faulty, not so much the two motor drivers?.
It is version 04.37.03 I haven't downloaded any software or firmware or the like to it,
I am thinking it should of been already to go when it was delivered,
( no software / firmware to be downloaded) is this an area also to look at,
Am i correct in saying i shouldn't have to load anything into it?
Just thinking if there is anything else that i have missed.
Last edited by bluesilver; 26-08-2018 at 04:20 PM.
|