Quote:
Originally Posted by Garbz
Don't go overboard on different sizes. The ones that came out of the mount were all identical sizes. 0.25mm I think. The kit I bought came with 0.1mm 0.2mm and 0.3mm sets from what I remember.
|
I had .25mm , .50mm and 1mm washers in mine. No correlation to what was needed.
What I need are 15 thou (.38mm) and 20 thou (.50mm) for below the worm gears.
I don't need any above the worm gears, the casings fit nicely without any. I'd rather have a better thrust surface than the bare casing metal, so a minimal sized washer is needed there.
The .1mm .2mm .3mm kit sizes would most likely do , stacked to accommodate the larger gaps.