View Single Post
  #525  
Old 17-01-2017, 06:47 PM
wasyoungonce's Avatar
wasyoungonce (Brendan)
Certified Village Idiot

wasyoungonce is offline
 
Join Date: Jul 2006
Location: Mexico city (Melb), Australia
Posts: 2,336
Finally an update.

Managed to fit FTDI LQFP64 and ATMega328P and associated power then tried programming them...ahhh yeah didn't go so well at first. I was getting the following error... "Error reading device" in MProg.

Apparently I needed to fit the EPROM IC DD2 to the PCB, MProg was not reading the FDTI properly because its EPROM was missing! Go figure. Sigh!

Anyway after installing it ..all went well. Fusebits done, ATMEGA328P programmed, cam86 ASCOM installed ok, connected to cam86 view fine. Although not much to see as the PCB only has enough fitted to do firmware.
Attached Thumbnails
Click for full-size image (IMG_3286-small.jpg)
191.8 KB66 views
Click for full-size image (cam86 view.PNG)
33.2 KB46 views
Reply With Quote