Thread: EQ6 Hypertune
View Single Post
Old 26-02-2010, 08:20 AM
allan gould's Avatar
allan gould
Registered User

allan gould is offline
Join Date: May 2005
Location: Brisbane
Posts: 4,485
Originally Posted by opticalsupports View Post
Allan, thanks for the heads-up. It makes perfect sense what you're describing. I didn't have that exact problem because I obsessed over aligning the flat spots with the set screws. It was tough because you can't see it very well as I remember.
Curt, I thought that I had also been obsessively careful as I marked it with a "sharpy" to know where the flat was but I must have been just a bit off and with the scope load rocking it back and forth, the screw gradually worked itself loose so that it went from perfect (No backlash or delay in reversing the motors) to a 7-8 sec delay in reversing the motors. Just something to be aware of.
Reply With Quote