Thread: Leveling
View Single Post
  #12  
Old 11-12-2019, 08:56 AM
alval (Alan)
Registered User

alval is offline
 
Join Date: Jun 2017
Location: Northern Adelaide
Posts: 41
If the pin supplied is m10 x1.25 that is a metric fine thread not a m10 x 1.5 which is standard. Im not sure you’ll find those drill taps in that configuration which are ok if not drilling and tapping too deep. Tapping drill for metric is diameter minus the thread pitch so 8.75 but they dont make this size. So 8.8 is what you can get for the tapping drill or 11/32 if you have imperial drills.
Al
Reply With Quote