|
I've pulled the camera apart, and it looks like I have "the old version" in the PDF that Martin posted above, Figure 2 left hand image. See my attached photo. Question time.
If I make it write protected, can it be undone easily if, for example, a firmware update needs to happen in the future?
The english in the document isn't crystal clear to me, and I don't find electronics intuitive. Is it just a matter of soldering those 2 right hand pins together? It mentions separating the pin from the board a couple of times. Early on says not to, then the unclear photo lower (Fig 3) seems to say to cut the wire.
Is there a software method of achieving this without soldering?
|