I added two new 'Cold finger Inside' paths in addition to the default (below).
Here is the schematic of the primary 'Cold finger Inside' path for a7S; I chose this location since it is where 'Cooler @ the base' TEC is located.
Note: I am coining the term 'Cooler @ the Base' for the active cooler to differentiate it from the 'Cold finger Inside' where 'Cold finger Inside' becomes an extension of the active cooler.
a7S is one of those cameras where 'Cooler @ the base' may be sufficient even if 'Cold finger Inside' were not installed given its compact body and well established default paths. Regards
Last edited by mmalik; 07-02-2017 at 05:37 PM.
|