Quote:
Originally Posted by rcheshire
The biggest issue is the camera getting wet. Sort out the protection requirements and then work out the cooling system details.
|
Thanks Rowland; this is exactly the mastery that goes in 'Cold finger Inside' mods. Each camera is unique so I design internal insulation (electrical & moisture) accordingly.
To give you one example, look at the
base of a7RII. First off it is all metal, no circuits. Second, I put in a thin layer of neoprene rubber insulation at this level to prevent any wetting.
Note: Neoprene goes in between the two layers shown; each image being a layer
This pretty much thermally isolates the whole bottom to prevent any inside wetting.
In short, each camera would have similar measures in place to prevent internal condensation. Regards