niharika,
Thank you.
Yes, I have been doing everything via HFD, so, that's good to note.
I just read the RoboFocus manual and I understand now that from the configuration screen, I can enter anything less than 64,000 in the current position box, and, it'll set it to that. That's very handy to know. I can set it to a ridiculously large number and not have to worry about it for a while (as you've mentioned). OK, so, all is not lost. It's not perfect, but, it will do for now (until I have complete automation).
I will, however, double-check and triple-check everything, again. I will tighten everything down as much as I can, from the set screws on the motor to the bracket, to the clutch, to the bracket on the focuser housing itself.
Cheers.
H
|