[multiweb (Marc)]

Originally Posted by NeilW

Thanks Marc. What brand focuser is that?

It was a GSO rail focuser.

Originally Posted by NeilW

Reading throug this post http://www.iceinspace.com.au/forum/s...light=sharpsky which ran to 80 posts, fitting required making up a bracket that wrapped around the whole (GSO) focuser

No you don't have to make a huge bracket. All you need is bolt a solid plate to a flat face on the focuser, then run from there to the motor.

When I see those massive curved robo-focus brackets I reckon it looks ugly and stupid TBH. Doesn't need to be that big. Just stay minimalist.
There's always a flat part under the focusing knob axis on the block. That's where you start from. The less drilling, the better.