View Single Post
  #916  
Old 04-10-2018, 09:19 PM
luka's Avatar
luka
Unregistered User

luka is offline
 
Join Date: Apr 2007
Location: Perth, Australia
Posts: 1,164
Important note:

After camera just has been switched on, during the first connection the software/driver may not set all the settings correctly. It was always doing this (since the original Ukrainian version) but I just figured out what was happening. No idea why yet.

The solution for now: After the camera has been powered on for the first time: connect, disconnect and re-connect again.

For example:
camera off -> camera on -> connect to camera -> possible PROBLEM -> disconnect from camera -> connect to camera -> NO PROBLEM

The following disconnections/reconnections are OK, it is only the very first time after the power was off where the issues may arise.
Reply With Quote