View Single Post
Old 02-11-2017, 09:49 AM

JA is offline
Join Date: Oct 2016
Location: Melbourne, Australia
Posts: 1,624
Hello leon,

Sorry to hear of your woes. Perhaps one of the ribbon cables is not fully seated in its mating connector or was pulled out slightly during reassembly. I can certainly imagine it might be possible when sliding the outer barrel or other parts OVER these cables. Are the cables stuck down in anyway to help avoid this? Hopefully there are no broken solder joints or cracked ribbon cable, but check for that as well. Are the camera and lens contact pins clean and able to move as required. Also clean the camera and lens contacts with contact cleaner, isopropyl alcohol or metho.

Good luck

Reply With Quote