how to find a thinner t-ring?
i have a dslr and a hotech field flattener with a zenithstar 66 sd. i am still getting a bit of curvature and by using spacers to extend the distance between FF and the sensor was making things worse. i want to try to get the FF closer but the inly way i canthink of to achieve this is to use a thinner t-ring. all the ones i have looked at seem to be about the same thickness.
i have thought about taking one to an engineer and getting him to thin it down except that they all seem to have 3 grub screws holding an inner ring(which the FF screws into)this ring could be screwed a little further into the outer t-ring by extending the thread. the problem as i see it when milling this t-ring down it will expose 3 holes from where the grub screws were. this could create a problem as a latche does not really like holes in a job being tooled)i hope i have explained this clearly and it's not too long or convoluted an explanation.
has anyone had any experience in how one might achieve a thinner t-ring or another method of getting the FF closer to the sensor?
any ideas opinions welcome.
thanks for looking.
|