View Single Post
  #24  
Old 05-07-2016, 07:58 PM
DavidTrap's Avatar
DavidTrap (David)
Really just a beginner

DavidTrap is offline
 
Join Date: Jun 2009
Location: Brisbane
Posts: 3,032
Hi Chris,

Finally reporting back in with the field test of the controller.

The temps at Leyburn were -2 degrees and there was a thick frost on the ground in the morning. The controller was covered in frost where I had it mounted on top of the optical tube. The temperature sensor was a snug fit into one of the collimation bolt holes on the lens cell. The front objective was clear of dew all night. On the occasions I checked the screen, it was running the heater at ~40% to maintain the lens cell 2-3 degrees above the dew point calculated by the unit. I had the dew strap wrapped around the outside of the dew shield - there’s a 1cm gap between the dew shield and lens cell, but it still worked fine.

I highly recommend this unit to others. I'm going to build another unit for a mate with a 14inch OTA - hopefully the mofset plus heatsink will cope with the higher amperage. Better do some calculations.

Thanks again for publishing this design.

DT

Last edited by DavidTrap; 05-07-2016 at 08:02 PM. Reason: added a bit
Reply With Quote