Thread: K3CCD Tools
View Single Post
  #3  
Old 15-03-2012, 06:42 AM
troypiggo's Avatar
troypiggo (Troy)
Bust Duster

troypiggo is offline
 
Join Date: Nov 2008
Location: Brisbane, Australia
Posts: 4,794
I've seen some guys asking same question in the K3CCDTools Yahoo Group and it's been like a bit of a ghost town in there. Guy the other day posted if Peter is ok, and no responses at all yet.

Re: drift aligning. Why not use PHD if you have that? Just point scope straight up, calibrate PHD and get it guiding, turn off dec guiding, watch the error graph slope of dec axis, adjust az until the slope of the graph goes flat. Then point just above horizon east or west, calibrate and get guiding, turn off dec guiding, watch the error graph slope in dec, and adjust alt until graph is flat. Repeat maybe one or 2 times and off you go.
Reply With Quote