View Single Post
  #71  
Old 11-05-2018, 07:06 PM
Stefan Buda
Registered User

Stefan Buda is offline
 
Join Date: Jul 2013
Location: Melbourne, VIC
Posts: 820
Making the necessary jigs and fixtures is more work than making the actual parts.
For the primary, I made a new wedge error tester, from an old tooling plate, that allows me to also measure the concentricity of the inner diameter.
For making the dovetail plate, I had to make a fixture for cutting the 60 degree angle of the dovetail.
Next I have to figure out a way of setting up the primary on the lathe to cylindrically grind the inner diameter to the required specs.
Attached Thumbnails
Click for full-size image (Primary4.JPG)
129.5 KB155 views
Click for full-size image (DovetailPlate1.JPG)
139.7 KB147 views
Reply With Quote