|
It's turned up and I'm in the process of fitting everything.
Just a quick question, and this will probably be something a g11 owner will know.
In fitting the encoder kit, there is a large gear with 6 pins in it, this is to be fitted to the axis via a set screw which is to be as follows " LOCK SET SCREW ON GEAR INTO SLOT ON SHAFT; TIGHTEN" my problem is there is no slot on shaft, now given this is pre the clutch knob, if I screw it up tight on the shaft then the clutch won't work quite right. The logic of a slot makes sense so it can adjust with the clutch.
So for now I'm going to just lock it onto the round shaft..... If I'm stuffing up let me know.
Clive
|