View Single Post
  #1  
Old 04-08-2019, 11:36 AM
chrisp9au's Avatar
chrisp9au (Chris)
Hitch Hiker

chrisp9au is offline
 
Join Date: Jan 2007
Location: Clifton Springs, Victoria
Posts: 767
Help! Nexstar SLT firmware update issues

I have successfully updated the hand control on my Nexstar SLT mount, from V 4.17 to V 4.22
It updated without a hitch, very happy, so happy I decided to update the Motor Control.
If only I hadn't!

I tried updating from V 5.14 to V 5.18
MCupdate reports "An Error occurred Programming Data at Address: 709" and recommended restarting the programming.
I have restarted it many times, getting errors at a number of different addresses.
After an hour I cancelled out and tried to re-install the old version V 5.14.
Same problems.Now my hand control cannot communicate with the mount!
Hand control says "No Response 16" which is the azimuth motor.




Has anybody experienced this? More importantly has anybody recovered from this?
Attached Thumbnails
Click for full-size image (Nexstar SLT MCupdate error.jpg)
90.8 KB15 views
Reply With Quote