Following
test results are from early on testing on a Canon 7DII during the development process; more to be presented in due time. Regards
TEST METHOD:
- A lamp was used to gradually warm up the camera (for ~2hours)
- A baseline reading was taken at this time with cooling module off
- Cooling module was started and a test reading was taken (after ~2 hours)
- Heat source was present throughout the test
- 3 meter RJ45/Ethernet cable was used for cooling module/power/PWM interconnectivity
- Baseline RAW...
- Test RAW...
Note: Small (identical) sections of corresponding in-camera JPGs shown, zoomed-in at 400%