View Single Post
  #135  
Old 25-07-2016, 05:54 PM
wasyoungonce's Avatar
wasyoungonce (Brendan)
Certified Village Idiot

wasyoungonce is offline
 
Join Date: Jul 2006
Location: Mexico city (Melb), Australia
Posts: 2,336
Thanks Luka..

I'd use our gerbers but it doesn't matter. There were some small issues I found with grims/faddy's layout, apart from small things like miss-naming or qty 2 R4's on base layer. The only major deviations were:

DS18B20 temp sensor is powered from 3.3V direct but the PCB had this powered from same 3.3V but after inductor DR6. Not a big issue really. This output from DR6 is also put to a pad "VDD", no reference about this on schematic, but I can do this.

VT1 schematic gate from pin 12 DD5, yet board shows this to be pin 13? Mine is put to pin 12.

DD5 pins 7 & 12 broken out to pads PB6 and PB0. Which I haven't yet done as this PB0 conflicts with VT1 gate pin from DD5. I need to look a little more closely at this.

Apart from these...just need to clean up orphans and layer restrictions. As you said, this also allows us some space for connectors etc.

edit:
Oh DD13 +5V supply was rotated wrong way..or something strange...on their board. Fixed on mine.
I can generate parts lists from Eagle PCB CAD....straight into places like digikey. As long as the parts were fully recognised.

Last edited by wasyoungonce; 25-07-2016 at 07:26 PM.
Reply With Quote