Quote:
Originally Posted by alistairsam
what I found very surprising was to see the white plastic spacer bolt pressing directly on the pins of a chip. I had to shim off a mm from the end of the bolt to reduce stress on the chip.
That I find could have been designed better by repositioning the plastic bolt or the chip on the pcb as they should have known where the bolt would have been relative to the pcb..
|
The older QHY-8 had the Whole CCD with mounted PCB taken right out of the Nikon D40 cameras. This was a Nikon issue, and again, the belief is its QHY design.
QHY design of the QHY-8 (Original) was from "After" the CCD ribbon cable. So tilt, and plastic lifts, etc was as it was right out of the Nikon camera body.
Back in those days, there were alot of D40 cameras selling without CCD's.
Im sure you'll find that suprizing too
.
Theo