Update:
I installed the Moonlite focusor with an Altair adapter and have the motor hooked up to a Robofocus control unit. The motor works well with the Robofocus software and manual controls.
Both cameras feed into a MHP which will directly connect to the FitPC. MHP and FitPC will ride on the same D bar. I need to tidy up the wiring a bit more yet.
I have also installed a dew heater on the secondary. I tested that tonight too and that works well. It gets quite warm on full power with the MHP contols, so I till try it on 3/4 first and that should be enough to eliminate dew. I will probably do something about the red insulation tape, I just need to work on eliminating the sideways movement of the cabling.
So nearly time for first light.
|