Quote:
Originally Posted by sopticals
Hi Frank,
how did you get the diagonals cut? Were they cut at 45degs? I have been trying to figure out how to cut 7" minor axis diagonals, from 35mm thick plate glass. Would much prefer the 45deg angle cut, rather than waterjet cut on the flat.
Best regards
Stephen
|
I have only rough cut them with the trusty angle grinder with diamond blade at this stage to about 145mm on the minor axis so as to have some in the middle that might be flat. I was then planning to cut closer to desired shape when polished, and then hand grind to final shape with the 45 deg. chamfer, hoping not to chip anything. I am very open to suggestions...
cheers Stephan,
Frank