Quote:
Originally Posted by acropolite
Can't find it now but I thought I saw a post somewhere suggesting that the Synscan software may have been reacting to discrepancies between the encoder values and the mount's position calculation, maybe there is no correlation but it wouldn't hurt to do some runs with the encoders turned off. I know for all my imaging sessions the encoders were turned on. When I get back and have some time I'll run both with encoders on and off and see if there's any difference.
@ h0ughy, did you have encoders on or off?? (I think on is default unless turned to off)
|
the controller was just about as setup from scratch, so if the default was off then it was off