thunderchildobs
04-02-2010, 12:14 AM
I have justed installed a Losmandy Dovetail mounting bracket to the underside of my 14inch Meade ACF scope. However the scope doesnt fit flush against the brackets. There are two small screws, one at the front, another at the back in the center of the scope that stop the brackets from fitting flush against the tube.
Can these screws be removed safetly?
Are the screws needed for holding the current plate in place?
Should the brackets have a counter sunk hole where the screws would go.
Will post a picture tommorrow.
Thanks
Can these screws be removed safetly?
Are the screws needed for holding the current plate in place?
Should the brackets have a counter sunk hole where the screws would go.
Will post a picture tommorrow.
Thanks